CUPRA Lip Installation Guide - Instruction
Be aware, this is just an example and we are not responsible for any demadges on your car or spoiler and we always recommend professional installation.
PLEASE read the whole instruction first, before you start!!!
Remove the yellow marked tabs and cut the center support (green arrows) down.
Here you can see the details: Cut the yellow marked tabs. The turquoise-colored dots show you where you have to drill holes.
Cut each center support down, as shown in the picture (green line). PLEASE make sure you are cutting the center supports and taps at your needs.
Here you can see, the center support is the same high as the right side of the spoiler.
Here are all tabs removed.
Best to positioned the spoiler with painters tape to mark the holes for the bumber and the ends from the spoiler where they have to be cut to match up with the fender.
The end of the spoiler - marked where it has to be cut
Spliter installed with bolds, ss-washer, lock-washer and nuts. At the end of the splitter you can see (the green circle) the end of the splitter which has to be cut.
